![]() For this transistor, the VGS is 20V, hence when we provide this voltage the MOSFET will be fully closed. The Gate Source Voltage (VGS) is a critical parameter while using the transistor. Thus by controlling the Voltage (VGS) we can switch the Mosfet hence the MOSFET is a voltage controlled device. If the Gate is provided with its gate source Voltage (VGS) then the MOSFET will be ON, that is the Drain and source pin will be connected together (Closed). ![]() If the gate is connected to Ground then the mosfet is off that is there will be no connection between Drain and source (Open). The Gate pin acts as a switch for turning ON or OFF the mosfet. Current always flows in through the Drain and flows out through the Source. This mosfet comes in a compact TO-92 package and has a threshold voltage of 3V, hence if you looking for a small mosfet to switch a load then this IC could suit your purpose.Ī Mosfet has three terminals - Drain, source and Gate. The 2N7000 MOSFET can be used to switch loads which operates on less than 60V (VDS) and 200mA (ID). MOSFET’s are power electronic switches just like transistors, but with a higher current and voltage rating. ![]() Note: Complete Technical Details can be found in the 2N7000 datasheet given at the end of this page.īS170, NTE 491, IRF3205, IRF540N, IRF9Z34N, IRFP250N, IRFZ44.ĢN7000 is a small signal N-channel MOSFET. Turn ON and Turn off time is 10ns each.Pulsed Drain Current (ID-peak) is 500mA. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |